A run out is a dismissal in which a fielder breaks the wicket while a batter is out of their ground. The bowler is not credited with it, the run being attempted does not count, and any runs the batters had already completed on that ball do. It is the dismissal that most often leaves club scorers unsure: which of the two batters is actually out, how many runs go into the total, and what to write in the “how out” column. This guide answers each, including the awkward cases of crossed batters, run outs off wides and no-balls, and run outs after byes.
What Is a Run Out?
Under the Laws of Cricket (Law 38), a batter is out run out if, at any time while the ball is in play and neither batter has been dismissed another way, they are out of their ground and the wicket is fairly put down by the fielding side. Three practical points follow:
- The ball must be live. If the ball is dead, the dismissal cannot happen.
- “Out of the ground” is about the bat or the body. A batter is safe if some part of their bat in hand, or their person, is grounded behind the popping crease. A batter running with the bat in the air, or whose bat bounces up after being grounded, is judged by the umpire on the facts, so the scorer relies on the umpire’s signal.
- The wicket must be put down. A fielder can do it by hitting the stumps directly with the ball, or by breaking the wicket with the ball in the hand. A direct hit and a relay throw produce the same dismissal.
A batter does not need to be running to be run out. A batter who has strayed out of their ground, to pat a pitch or to talk to a partner for example, can be run out if the ball is live and a fielder breaks the wicket. A related case where the non-striker leaves early is covered separately in our guide to mankading.
Which Batter Is Out?
This is the question that causes arguments at the scorers’ table. The rule is simple to state: the batter out is the one whose ground is at the end where the wicket was put down, and “whose ground” depends on whether the batters have crossed.
| Situation | Who is out |
|---|---|
| Batters have not crossed; wicket broken at the striker’s end | The batter at (or nearest) that end who is out of their ground |
| Batters have crossed; wicket broken at the end they were running towards | The batter who was running to that end, the one who has crossed |
| Batter wandering out of the crease, no run attempted | That batter, if the wicket is broken at their end |
Worked example. The striker, Ali, pushes to mid-off and sets off for a single with the non-striker, Ben. They cross in the middle of the pitch. The fielder throws to the bowler’s end and breaks the wicket before Ben gets home. Ben was running towards the bowler’s end, so Ben is out, not Ali, even though Ali was the one who hit the ball. If instead the fielder hit the striker’s-end stumps while Ali was short of the crease there, Ali would be out, not Ben. The scorer records the dismissed batter by name, not by “striker” or “non-striker”, so the right name goes against the right line.
The umpires decide this. The scorer does not choose which batter is out, but the scorer must note the batters’ ends correctly so the next ball is credited to the right person. If you are unsure who is now on strike, ask the umpires to confirm at the next ball rather than guessing.
Do the Runs Count?
When a batter is run out, the Laws give the scorer three simple instructions:
- The run in progress when the wicket is put down is not scored.
- Any runs the batters had already completed on that delivery are scored.
- Any penalty runs awarded to either side on that delivery are also scored. See penalty runs in cricket.
Example. The batters take one run, turn, and go for a second. The throw breaks the stumps before the second run is completed. One run counts, the second does not, and one batter is out. The over then continues as normal. The ball counts as a legal delivery faced by the striker, one run is credited to whoever hit the ball, and the wicket is recorded as run out.
If one batter was short earlier in the same sequence, the umpire’s short-run call is applied first, then the run out. Wait for the umpires to finalise their signals before writing the total.
Run Outs Off Wides, No-Balls, Byes and Leg Byes
A run out can follow any kind of delivery. It changes only how the runs are labelled, not whether the dismissal stands.
| Delivery | Can a batter be run out? | What the scorer records |
|---|---|---|
| Legal ball, runs off the bat | Yes | Completed runs to the striker, wicket to the fielding side, no bowler credit |
| Wide | Yes | The 1-run wide stands, plus any runs completed before the run out, all as wides. Ball is not counted in the over |
| No-ball | Yes. Run out is one of the few dismissals allowed | The 1-run no-ball stands, plus completed runs. Runs off the bat go to the striker. Ball is not counted in the over |
| Bye or leg bye | Yes | Completed runs are byes or leg byes, not credited to the striker. Ball counts as a legal delivery |
| Free hit | Yes. See the free hit rule | Recorded exactly like any other run out |
The important consequence is that the bowler is charged for the wide or no-ball extra and for runs scored off the bat, but not credited with the wicket. A run out never appears in a bowler’s wicket column, which is why a bowler’s figures can look expensive on a day when the team took several run outs. Our guide to cricket extras sets out which extras count against the bowler.
Run Out vs Stumped
The two dismissals look alike because both involve the wicket being broken with the batter out of the ground. The difference is the batter’s action and the wicketkeeper’s role:
- Stumped: the batter is out of their ground not attempting a run after playing at a legal delivery, and the wicketkeeper breaks the wicket. The bowler gets the wicket.
- Run out: the batter is out of the ground while running, or otherwise out of the ground without being stumped. The bowler gets nothing.
The scorer takes the umpire’s decision. If a batter misses the ball, the keeper gathers and breaks the stumps with the batter out of the ground, it is normally stumped. If the batter set off for a run (a bye, for example) and the keeper broke the wicket, the umpire will usually give run out. Where it matters, as it does for a wicketkeeper’s stumping tally, make a note and confirm with the umpire.
How the Scorer Records a Run Out
- Name the batter who is out in the scorebook, with their final score and balls faced.
- How out: write run out followed by the fielder who broke the wicket in brackets, for example run out (Patel). When the ball passes through two fielders, many competitions name both, such as run out (Patel/Singh). Conventions vary, so follow your league’s scorebook key.
- Bowler column: leave blank. No wicket is credited to the bowler.
- Runs: add the runs completed before the run out, labelled as bat runs, byes, leg byes, wide or no-ball extra, as above. Do not add the run in progress.
- Fall of wickets: record the team score and the over, for instance 3-87 (Ben, 14.2 ov), with the score including the completed runs.
- New batter and strike: note which end the incoming batter takes and who faces the next ball.
Check the book at the end of the over: a run out is the dismissal most likely to cause an end-of-innings discrepancy, because the runs and the ends were both in play at once. The scorebook balance checker compares the batting runs plus extras with the bowlers’ figures, and the over notation decoder will confirm an over written in shorthand.
Common Scoring Mistakes With Run Outs
| Mistake | Correct approach |
|---|---|
| Crediting the wicket to the bowler | Leave the bowler column blank for a run out |
| Adding the run in progress | Only runs completed before the wicket was broken count |
| Assuming the striker is always the batter out | Either batter can be out. Record the one whose end the wicket was broken at |
| Forgetting the wide or no-ball run when the run out came off one | The extra stands whether or not the batter is out |
| Counting the ball as legal after a wide or no-ball | It does not count in the over, so the bowler bowls an extra ball |
| Leaving out the fielder’s name | Name the fielder who broke the wicket, so fielding awards and averages are right |
Run Outs and Averages
A run out ends a batter’s innings, so it counts as a dismissal for their batting average. It does not count towards the bowler’s wickets or bowling average. If you keep season statistics, check that your system treats run outs this way. Our guide to batting average shows how a dismissal changes the figure, and the end-of-season averages guide covers the not-out count.
Score Run Outs Correctly with CricPulse
Recording a run out by hand means choosing the right batter, the right fielder, the completed runs and the next striker, all in a few seconds while play continues. Want to record this automatically during your next match? Score your match with CricPulse, where a run out prompts for the dismissed batter and the fielder and then keeps the score, fall of wickets and bowling figures consistent.
Frequently Asked Questions
What is a run out in cricket?
A run out is a dismissal where a fielder puts the wicket down while a batter is out of their ground and the ball is in play, usually while the batters are running between the wickets. The bowler is not credited with the wicket.
Which batter is out if the batters have crossed?
The batter who was running towards the end where the wicket was broken is out. If the batters had already crossed, that is the batter who was heading to that end, not the one who started there. If they had not crossed, it is the batter who is nearer that end and out of their ground.
Does the run count if a batter is run out?
The run being attempted when the wicket is broken does not count. Runs the batters had already completed before that do count, together with any penalty runs awarded to either side.
Can you be run out on a no-ball or a wide?
Yes. Run out is one of the few ways a batter can be dismissed off both a no-ball and a wide. The extra for the no-ball or wide still stands, and runs completed before the run out are added.
Does the bowler get a wicket for a run out?
No. A run out is not credited to the bowler. It is credited to the team as a wicket in the fall of wickets, and the fielder or fielders involved are usually named on the scorecard.
Can a batter be run out when not attempting a run?
Yes. If a batter is out of their ground, for example after wandering out to play a shot or leaving the crease to talk to a partner, and a fielder breaks the wicket while the ball is live, they can be run out even though no run was being attempted.
How do you write a run out in the scorebook?
Record the batter’s name, the words run out with the fielder who broke the wicket in brackets (for example run out (Patel)), no bowler credit, the runs completed on that ball, and the score and over number for the fall of wickets. Where two fielders were involved some competitions name both.